Download M-Horse M8 Pac Firmware 100% Tested

Note

Follow the instructions on how to flash the device carefully below

I will not take responsibility on whatever may happen to your device.

Make sure you are downloading the exact ROM of the device you want to flash because 

 flashing a wrong firmware, can render the device useless 

(can't power on, can't charge and will not be detected by a computer)

You can also use tools like MiracleBox, infinity CMII, Volcano, GPG Dragon etc to flash or upgrade SPD devices

M-HORSE M8 QUICK SPECS

3.5 - inch WVGA Touchscreen, 320 x 480 pixels

1.0 GHz single core processor

SC6820

 256MB RAM

256MB Internal Memory 

up to 32GB microSD

2MP Rear Camera, LED Flash, Auto Focus

VGA Front Camera 

Dual SIM

EDGE , GPRS - 850 / 900 / 1800 / 1900MH

WIFI 802.11 b/g/n

bluetooth 2.1

1200mAh Battery

M-HORSE M8 STOCK ROM
S80v13_jhm_b16_NGR_GSL1688_256M_v01

DOWNLOAD ROM

HOW TO INSTALL THIS ROM

 These are the instructions to flash .Pac Stock ROM on any android Smartphone using Spreadtrum Upgrade Tool.

Remember: Your Android device should have at least 40-50 percent of battery to perform the flashing process. 

Flash Pac Stock Rom on Android Smartphone 

Step 1: Download and Install Spreadtrum USB Driver on your Computer. If in case Spreadtrum Driver is already installed on your computer then SKIP this Step.

Step 2: Download Stock Rom (.pac) for your Android Device.

Step 3: Download and extract Spreadtrum Upgrade Tool on your computer. After extracting,you will be able to see many files.

Step 4: Now, open UpgradeDownload.exe.

Step 5: Once Spreadtrum Upgrade Tool is launched, connect your Android device to the computer (make sure your device is switch off).

Step 6: Once your Smartphone is connected successfully to the computer, click on the Load Packed Button and add the .pac file (stock rom which comes as pac).

Step 7: Once you have successfully added the Pac file in Spreadtrum Upgrade Tool, click on the Start Downloading button to begin the flashing (hold download button to start the flashing process,the button usually up or down button and plug in your cable to begin flashing).

Step 8: Once flashing is completed, you will be able to see the Green Passed Message in Spreadtrum Upgrade Tool.

Step 9: Now you have successfully flashed your Android Device using Spreadtrum Upgrade Tool.

     Once you see the Green Passed Message,Disconnect it and ON your phone.Go to Settings > About Phone > Check firmware.

Then you are Good to go........Enjoy.