Guide To Flash Condor Griffe T1 SP413 SC9832A Nougat 7.0 SPD Flashtool Method

CONDOR GRIFFE T1 SP413 ANDROID 7.0 SPD FLASHTOOL FACTORY FIRMWARE

INFO:

Model Name  : Griffe_T1
Model Brand : Condor
Model Device: Griffe_T1
AndrVersion : 7.0
BaseBand CPU: SP9832A_2H11_VOLTE
Project Ver : SP413_V12_20170801
Model Ext   : SP413

PRE-REQUISITE

• This is for Condor T1 only.
• Your device must have 70% Of battery.
• You need a Laptop or PC to perform this Action.
• Download the right firmware for G-Tide V5 from the link bellow.
• Back Up your Data to make sure you have data’s in case if something Wrong (This Process won’t loose your data)
• Make sure you have followed the steps properly. Don’t Skip and Read!
• We are not responsible for any damage that you make to your Phone.

WHY YOU NEED TO FLASH YOUR PHONE!!

You need this firmware/stock rom if you have encountered this kind of problem in your Smartphone Listed Below:

1.Hang on logo.
2.Rebooting.
3.Bootloop & Dead boot after a wrong software.
4-Virus & Sexual Apps.
5-System crashing

How to know if the phone had a hard problem (Emmc problem)??

• What is Emmc problem? also called read mode only,  it means that your internal memory doesnt accept command, so the phone stay on the same condition after a software or a hard reset.
•  if the phone hang on logo after flash, you ara facing Emmc problem.

DOWNLOAD AREA:

Firmware Download Link: HERE Or FROM HERE
Password For Firmware: www.dzgsm.com
SPD Flashtool Downloadlink: SPD FlashTool ResearchDownload
Drivers Download Link: Mobile SPD Drivers

GUIDE TO FLASH WITH RESEARCH DOWNLOADER

1- Open the Research download tool
2. Launch ResearchDownload.exe

3- Click on the Load Packet icon (top left corner)

4- A window will pops up, navigate to the location of the .pac file, select it then click Open

5- The pac file should now be loaded (its name should appear at the top)

6- Click the Settings Icon (top left corner)

7- In the box that pops up, untick any item(s) you do not wish to flash then click OK. Ignore this step if you wish to flash all files

8- Click the Start downloading button

9-You should see Waiting.... under the Progress bar

10. Switch off the phone (still with battery inside) then connect it to the PC via USB cord (note that you might need to hold the volume down and volume up buttons  while connecting to PC on some phones) and flashing should begin. DO NOT interrupt

11- Once flashing is complete, you'll see Passed

12- Click on the Stop downloading icon then disconnect the phone from PC and boot