Wiko Lenny Dead After Flashing (Dead Boot)

First, you need to disassemble the phone and take the mother board out of the frame. 

There should be a few golden small circles with corresponding labels such as RX, TX, GND, VCC, VCHARGE, DM, DX, and many more. These are referred as "test points" but among them we only need to locate a certain one to allow the Wiko Lenny to boot again on the computer.

On the board, check something like "COLO" or "KOLO" or "KCOLO." Using a soldering iron connect the said point to the ground (GND). In some other phones this test point isn't visibly written, in case try any point but avoid pins which is 4.x volts or higher, or else your device will gone forever. Well, for the case of Wiko Lenny you don't need to look for KCOLO. Since, I practically tested it at my workshop Dorado Soft Touch Gsm Clinic

Success......if you find the solution difficult kindly update us to guide you
If you find the above guide useful please use the comment button
WE LOVE COMMENTS